RAM 2500 Van V8-5.2L VIN Y (1998)
Evaporative Emission Control Canister: Service and Repair
EVAP Canister
Two EVAP canisters are used. The canisters are mounted to a common bracket located under the left side of vehicle behind the drivers door well.
REMOVAL
1. Remove 2 bolts retaining canister bracket assembly to body.
2. Carefully lower the assembly and remove fuel tubes/lines at each EVAP canister. Note location of tubes/lines before removal for easier
installation.
3. Remove canister mounting nuts.
INSTALLATION
1. Position each canister to bracket and install nuts Tighten to 8 Nm (71 in. lbs.) torque.
2. Install fuel tubes/lines to canister.
3. Position assembly to body. Note locating ears at upper part of mounting bracket. Position these ears into notches on body.
4. Install 2 bracket bolts and tighten to 10 Nm (95 in. lbs.) torque.
