RAM 2500 Van V8-5.2L VIN Y (1998)
-
If a rubber grommet is located between the bottom of filter/regulator and top of fuel pump module, it can be serviced separately. Refer to the
following procedure.
-
If this grommet is not used, it cannot be serviced separately The Fuel Pump Module assembly must be replaced. Refer to Fuel Pump Module
Removal/Installation for procedures.
WARNING: The fuel system is under a constant pressure, even with engine off. Before servicing the fuel filter/fuel pressure regulator, the fuel
system pressure must be released.
TIP: Fuel pump module removal is not necessary.
REMOVAL
1. Drain fuel tank and remove tank.
-
Refer to Fuel Tank Removal/Installation.
Fig 22 Filter/Regulator Location
2. The fuel filter/regulator is pressed into a rubber grommet.
-
Remove by twisting and pulling straight up (Fig. 23).
CAUTION: Do not pull the filter/regulator more than three inches from the fuel pump module. Damage to the coiled fuel tube (line) may result.
Fig 24 Plastic Tube And Snap Ring -- Typical
3. Remove the snap ring retaining the convoluted tube (cover) to the filter/regulator (Fig. 24). Slide the plastic tube down the fuel tube to clear the
fuel tube clamp.