RAM 2500 Van V8-5.9L VIN Z (1997)
3.
Verify that there is 1.5 mm (0.060 in.) clearance between the top of the upper roller and the track (Figure 6). Adjust the clearance by loosening the
front upper bracket screws (Figure 7) and moving the bracket up or down until the proper clearance is obtained. Tighten the screws to 41 Nm (30
ft. lbs.) of torque.
NOTE:
VEHICLES BUILT BEFORE JAN. 2, 1996 (MDH 0102XX) MAY REQUIRE UPPER ROLLER P/N 55347146. THIS REVISED UPPER
ROLLER HAS A LONGER SHOULDER AND WILL ALLOW FOR A MORE UPWARD ADJUSTMENT.
4.
Loosen the lower roller bracket screws (Figure 3). Move the door in or out until the lower corner of the door is flush with the B-pillar with the
door closed. Tighten the screws to 41 Nm (30 ft. lbs.) of torque.
5.
Loosen the rear striker screws and install or remove spacers (p/n 55346527) (Figure 8) until the striker is in the center of the latch (Figure 1).
Then, move the striker in or out until the rear of the door is flush with the C-pillar. Tighten the screws to 23 Nm (200 in. lbs.) of torque.
NOTE:
