dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Blower Fan - Operates On High Speed Only|Page 5920 > < Blower Fan - Operates On High Speed Only|Page 5914
Page 1
background image

Blower Motor Resistor: All Technical Service Bulletins
Blower Fan - Operates On High Speed Only

NO: 24-05-97

GROUP: Heating & A/C

DATE: Apr. 18, 1997

SUBJECT: 
Blower Fan Operates On High Speed Only

MODELS: 
1997 (AB) Ram Van/Wagon

NOTE

THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH HEATER ONLY PACKAGES (NO AIR CONDITIONING) BUILT BEFORE
JAN. 23, 1997 (MDH 0123XX). HEATER ONLY VEHICLES BUILT AFTER THAT DATE CAN BE IDENTIFIED BY THE INSTALLATION
OF AN EVAPORATOR INTO THE HEATER HOUSING.

SYMPTOM/CONDITION:
 
Heater blower fan motor does not operate on LOW or MED. speeds but functions normally on HIGH.

DIAGNOSIS:

Turn the ignition key to the RUN position. Operate the blower motor switch in LOW, MED, and HIGH speed positions and note blower motor fan
operation. If the blower motor fan operates in the HIGH position but fails to operate in the LOW or MED. positions, perform the following Repair
Procedure. If the blower motor does not operate in any position, perform a complete diagnosis of the blower motor electrical circuit. Refer to the 1997
Ram Van/Wagon Service Manual (Publication No. 81-370-7107), page 24-14 for information regarding blower motor diagnosis.

PARTS REQUIRED:

1

05003333AA

Resistor, Blower Motor

REPAIR PROCEDURE:

This bulletin involves replacing the blower motor resistor with a revised part.

1.

Record all radio station presets.

2.

Disconnect and isolate the battery negative cable.

3.

Unplug the wire harness connector from the blower motor resistor (Figure 1).

Blower Fan - Operates On High Speed Only|Page 5920 > < Blower Fan - Operates On High Speed Only|Page 5914