RAM 2500 Van V8-5.9L VIN Z (1997)
Evaporative Emission Control Canister: Service and Repair
Fig 2 EVAP Canister Location
REMOVAL
1. Remove fuel/tubes at EVAP canister. Note location of tubes/lines before removal for easier installation.
2. Remove mounting bolt at canister mounting strap.
3. Remove canister and two piece strap from mounting bracket.
INSTALLATION
1. Place canister at a 45 degree position in mounting bracket.
2. Install canister and both mounting straps to mounting bracket.
3. Install canister bolt and tighten to 10 Nm (95 in. lbs.) torque.
4. Install fuel tubes/lines to canister.
