RAM 2500 Van V8-5.9L VIN Z (1997)
8. Remove cable from vehicle.
Fig 44 Throttle Cable At Throttle Body -- Typical
INSTALLATION
1. Snap the cable end onto lever pin (Fig. 44). On models with V-8 engines, be sure cable is routed under plastic cam (Fig. 44).
2. Connect cable to throttle body mounting bracket (push down and lock).
3. Install the remaining cable housing end into the dash panel opening (snaps into position).
Fig 43 Index Tab And Slot
4. Install the ball end of the cable wire through the hole in the pedal arm.
-
Install the plastic cable retainer.
-
The plastic retainer is snapped into the pedal arm.
-
When installing the retainer to the accelerator pedal arm, note the index tab on the pedal arm (Fig. 43).
-
Align the index slot (Fig. 43) on the plastic retainer to this index tab.
5. Operate and test the throttle before starting engine.
6. Install air cleaner housing.
7. Install engine cover.
