RAM 2500 Van V8-5.9L VIN Z (1997)
15.
Install the new cover over the AECM and install the four cover-to-AECM screws (Figure 5). Tighten the screws to 20 in-lbs (2.3 N.m).
NOTE:
On some conversion vans, the new AECM cover may interfere with the seat riser that was installed by the conversion company. On these
vehicles, remove the affected part of the cover by cutting it along the provided score lines using a hacksaw or similar tool (Figure 6).
16.
Install the driver's seat assembly into the vehicle.
17.
Install the nuts that attach the driver's seat riser to the floor (Figure 2). Tighten the nuts to 55 ft-lbs (75 N.m).
18.
Connect the seat belt switch wiring connector.
19.
Connect the power driver seat. wiring harness connector and attach it to the front riser crossmember (if equipped) (Figure 2).
2O.
Attach the riser trim shield to the rear of the driver's seat riser with the push-in fasteners (if equipped) (Figure 1).
21.
Turn the ignition switch to the "RUN" position.
22.
Connect the negative battery cable.
23.
Check the old AECM part number that was recorded in Step 10.
^
If the old AECM part number was 56007181, the vehicle restraint system does NOT include a pretensioner and the AECM software must be
updated (early-i995 model year vehicles only). Continue with Section "B" - Update AECM Software.
^
If the old AECM part number was 56043105, the vehicle restraint system includes a pretensioner. Continue with Step 24.
24.
From outside the vehicle, turn the ignition switch to the "OFF" position for about 10 seconds and then turn it back to the "RUN" position.
25.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
NOTE:
If the airbag warning light fails to light, or lights and stays on, there is a system malfunction. Refer to the proper Body Diagnostic Procedures
manual to diagnose and repair the problem.
B. Update AECM Software on Early Built 1995 Vehicles Only
