RAM 2500 Van V8-5.9L VIN Z (1997)
c. Hold shuttle valve in place.
d. Compress secondary spring and install E-clip in groove at end of shuttle valve.
e. Verify that spring and E-clip are properly seated before proceeding.
8. Install shuttle valve cover plate. Tighten cover plate screws to 4 Nm (35 inch lbs.) torque.
9. Install 1-2 and 2-3 valve governor plugs in valve body.
10. Install shuttle valve primary spring and throttle plug.
11. Align and install governor plug cover. Tighten cover screws to 4 Nm (35 inch lbs.) torque.
Boost Valve and Brace Assembly
1. Position valve body assembly so lower housing is facing upward.
2. Lubricate tube ends and housing ports with transmission fluid or petroleum jelly.
3. Start tube in lower housing port first. Then swing tube downward and work opposite end of tube into upper housing port.
4. Insert and seat each end of tube in housings.
5. Slide tube brace under tube and into alignment with valve body screw holes.
6. Install and finger tighten three screws that secure tube brace to valve body housings.
7. Bend tube brace tabs up and against tube to hold it in position.
