RAM 2500 Van V8-5.9L VIN Z (1997)
20. Attach solenoid case connector to 3-4 accumulator with shoulder-type screw. Connector has small locating tang that fits in dimple at top of
accumulator housing. Seat tang in dimple before tightening connector screw.
21. Install solenoid assembly and gasket. Tighten solenoid attaching screws to 8 Nm (72 inch lbs.) torque.
22. Verify that solenoid wire harness is properly routed. Solenoid harness must be clear of manual lever and park rod and not be pinched between
accumulator housing and cover.
Governor Body, Sensor and Solenoid Assembly
1. Turn valve body assembly over so accumulator side of transfer plate is facing down.
2. Install new O-rings on governor pressure solenoid and sensor.
3. Lubricate solenoid and sensor O-rings with clean transmission fluid.
4. Install governor pressure sensor in governor body. Then secure sensor with M-shaped retaining clip.
