RAM 2500 Van V8-5.9L VIN Z LDC (2000)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Rear Wheel Antilock Brake System
REMOVAL
1. Remove left turn signal housing.
2. Remove the extension panel under the left turn signal housing opening.
Access Cover
3. Disconnect the horn connector and remove the access cover mounting bolts. Remove access cover.
4. Remove one brake line from the rear antilock valve through the access cover opening.
5. From the engine compartment, disconnect antilock valve harness connector from the controller.
6. Remove the other brake line and mounting bolt from the antilock valve.
7. Remove rear antilock valve.
INSTALLATION
1. Position rear antilock valve on the valve bracket.
2. Install the mounting bolt and tighten to 24 Nm (18 ft. lbs.).
3. Install the brake lines and tighten to 15 Nm (130 inch lbs.).
4. Connect valve wiring harness to the controller.
5. Connect the horn connector and install the access cover and mounting bolts.
6. Install the extension panel.
7. Install left turn signal housing.
8. Fill and bleed base brakes system.
