RAM 2500 Van V8-5.9L VIN Z LDC (2000)
Wheel Speed Sensor: Service and Repair
Four Wheel Antilock Brake System
Front Wheel Speed Sensor
REMOVAL
1. Raise and support vehicle.
2. Disconnect speed sensor from the main harness.
3. Remove sensor mounting bolt from the steering knuckle.
4. Remove the sensor from the steering knuckle.
INSTALLATION
CAUTION: A special bolt is used to attach the sensor. Use only a factory replacement bolt.
1. Install the sensor into the steering knuckle.
2. Install mounting bolt and tighten to 15 Nm (11 ft. lbs.).
3. Connect sensor wire to main harness and ensure wire is routed away from hot or moving components.
4. Remove supports and lower vehicle.
Rear Wheel Speed Sensor
REMOVAL
1. Raise and support vehicle.