RAM 2500 Van V8-5.9L VIN Z LDC (2000)
used.
(c) Position the drive belt over all pulleys except the idler pulley (located between the generator and A/C compressor).
(d) Attach a socket/wrench to the pulley mounting bolt of the automatic tensioner.
(e) Rotate the socket/wrench clockwise. Place the belt over the idler pulley. Let tensioner rotate back into place. Remove wrench. Be sure belt is
properly seated on all pulleys.
(f) Install PCM.
The following belt routing schematics are published from the latest information available at the time of publication. If anything differs between these
schematics and the Belt Routing Label, use the schematics on Belt Routing Label. This label is located in the engine compartment.
(8) Fill cooling system.
(9) Connect battery negative cable.
(10) Start and warm engine. Check for leaks.
(11) Install engine cover (if A/C equipped).
