RAM 2500 Van V8-5.9L VIN Z LDC (2000)
Fig.38 Throttle Cable At Throttle Body (Typical)
6. Operate the throttle body lever (by hand) to the full open throttle position. Slip the cable end rear- ward from pin on throttle lever (Fig. 38).
Fig.39 Cable Release Tab (Typical)
7. Remove cable housing at throttle body mounting bracket by pressing forward on release tab with a small screwdriver (Fig. 39). To prevent cable
housing breakage, press on the tab only enough to release the cable from the bracket. Lift the cable housing straight up from bracket while pressing
on release tab. Remove cable housing.
8. Remove cable from vehicle.
INSTALLATION
1. Snap the cable end onto lever pin (Fig. 38). On models with V-8 engines, be sure cable is routed under plastic cam (Fig. 38).
2. Connect cable to throttle body mounting bracket (push down and lock).
3. Install the remaining cable housing end into the dash panel opening (snaps into position).
