dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

ABOUT US
Engine Coolant Temperature (ECT) Sensor <--> [Coolant Temperature Sensor/Switch (For Computer)] > < Component Locations|Page 2211

RAM 2500 Van V8-5.9L VIN Z LDC (2000)

Page 1
background image

Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor

The Camshaft Position Sensor is located in the distributor.

REMOVAL

1. Remove engine cover.
2. Disconnect negative cable from battery.
3. Remove distributor cap from distributor (two screws).
4. Disconnect Camshaft Position Sensor wiring harness from main engine wiring harness.
5. Remove distributor rotor from distributor shaft.
6. Lift the Camshaft Position Sensor assembly from the distributor housing.

INSTALLATION

1. Install Camshaft Position Sensor to distributor. Align sensor into notch on distributor housing.
2. Connect wiring harness.
3. Install rotor.
4. Install distributor cap. Tighten mounting screws.
5. Install engine cover.

Engine Coolant Temperature (ECT) Sensor <--> [Coolant Temperature Sensor/Switch (For Computer)] > < Component Locations|Page 2211