RAM 2500 Van V8-5.9L VIN Z LDC (2000)
should also be aligned to locking tab slot.
c. Press on lock cylinder until retaining pin engages.
d. Rotate key to OFF position.
e. Check for proper retention of lock cylinder by attempting to pull out on lock cylinder.
2. A 2-5/8" long plastic spacer is attached to inside of upper shroud. Before positioning shroud to column, verify spacer is tightened to upper shroud.
3. Position upper shroud to steering column.
4. Install 2 upper shroud screws.
5. Position rubber shields for shift lever and multi-function switch into upper shroud.
6. Position lower shroud hooks into pins on upper shroud.
7. Snap lower shroud to upper shroud.
8. Install 2 lower shroud screws.
9. Install tilt-wheel lever (snaps in).
10. Shifter should lock in PARK position when key is in LOCK position. Shifter should unlock when key rotated to ON position.
11. Check for proper operation of ignition switch in ACCESSORY, LOCK, OFF; ON, RUN, and START positions.
12. Steering wheel should lock when key is in LOCK position. Rotate steering wheel to verify. Steering wheel should unlock when key is rotated to
ON position.
13. Connect negative battery cable to battery.
