RAM 2500 Van V8-5.9L VIN Z LDC (2000)
the screws to 1.9 Nm (17 in. lbs.).
4. Align the five snap features on the upper edge of the passenger side airbag door with the receptacles on the instrument panel base trim.
5. Press firmly on the passenger side airbag door over the snap feature locations until each of the snap features is fully engaged in its receptacle. Be
certain that each of the snap features is fully engaged in the instrument panel receptacles.
6. Reach through and above the glove box opening to access and reconnect the passenger side airbag module wire harness connector to the
instrument panel wire harness connector, which is secured to the instrument panel structural support armature. Be certain that the passenger side
airbag module wire harness connector is fully engaged and latched.
7. Roll the glove box back up into the instrument panel.
8. Do not reconnect the battery negative cable at this time.
