RAM 2500 Van V8-5.9L VIN Z LDC (2000)
ASSEMBLY
1. Lubricate O-ring seal with power steering fluid.
2. Install O-ring into housing.
3. Install plug, tap lightly with a plastic mallet to seat it.
4. Install retaining ring with open end 25 mm (1 inch) from access hole.
5. Adjust pitman arm shaft, refer to Adjustments, Over-Center Adjustment.
Pitman Shaft/Seals/Bearings
DISASSEMBLY
1. Clean exposed end of pitman shaft and housing with a wire brush.
2. Remove preload adjuster nut.