RAM 3500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1998)
Main Bearing Bolt Tightening Sequence
12. Tighten the bolts evenly in the sequence shown using the following torque steps.
-
STEP 1-Tighten all bolts in sequence to 60 Nm (44 ft. lbs.) torque.
-
STEP 2-Tighten all bolts in sequence to 90 Nm (60 ft. lbs.) torque.
-
STEP 3-Tighten all bolts in sequence an additional 90°.
13. Turn the crankshaft to determine that it will rotate freely all 360°. Check the main bearing cap installations and/or the bearing sizes if the shaft
does not turn easily.
Position Of Dial Indicator
14. Push the crankshaft towards one end of its thrust and place a dial indicator as shown.
Crankshaft End Clearance
15. Zero the indicator needle and push the crankshaft towards the other end of its thrust and record the crankshaft end clearance.
