dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine Oil Dipstick - Incorrect From Factory|Page 1774 > < Engine Oil Pressure|Specifications|Page 1765
Page 1
background image

Engine Oil Dip Stick - Dip Stick Tube: Customer Interest
Engine Oil Dipstick - Incorrect From Factory

NO: 09-06-98

GROUP: Engine

DATE: Oct. 30, 1998

SUBJECT:
Incorrect Engine Oil
Dipstick

MODELS:

1998 (BR/BE) Ram Truck

NOTE:

THIS INFORMATION APPLIES TO VEHICLES EQUIPPED WITH 24 VALVE CUMMINS DIESEL ENGINES.

DISCUSSION:

1998 24 valve diesel engines were built with an incorrect dipstick calibration. This incorrect marking causes an overfilled condition of approximately
1-1/2 quarts when at the top end of the safe zone on the dipstick.

This overfill condition is not damaging to the engine but can cause the following:

Unusual engine noises.

Potential low power complaints.

Possible low oil pressure concerns due to oil aeration while driving on off-road terrain.

PARTS REQUIRED:

1

05014562AA

Dipstick (Cummins p/n 3935648)

NOTE:

THE CUMMINS PART NUMBER IS STAMPED ON THE DIPSTICK. THE INCORRECT CUMMINS P/N IS 3944594.

REPAIR PROCEDURE:

This bulletin involves replacing the dipstick with a revised part and adjusting the oil level.

1.

Remove and discard the engine oil dipstick.

2.

Install dipstick p/n 05014562AA.

3.

Adjust the oil level to the proper height.

Engine Oil Dipstick - Incorrect From Factory|Page 1774 > < Engine Oil Pressure|Specifications|Page 1765