RAM 3500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1998)
Adjustment Of Wastegate Actuator
4. To adjust the wastegate linkage, apply air pressure to the actuator to release the spring tension on the lever. Remove the control rod from the
wastegate lever. Pull the wastegate lever toward the actuator (closed position).
5. Adjust the length of the clevis end of the control rod to align the clevis pin hole to the wastegate lever. Install the adjusting link and retaining clip.
CAUTION: DO NOT pull, push or force the alignment of the clevis pin.
6. After the adjustment is complete, tighten the actuator rod jam nut.
7. Recheck the travel on the wastegate control rod. Adjust, if necessary.
