RAM 3500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1998)
Yoke Installation
7. Seat yoke on pinion shaft with Installer D-191 and Wrench 6719.
8. Remove the tools and install the pinion yoke washer and nut.
CAUTION: Do not exceed the minimum tightening torque when installing the pinion yoke retaining nut at this point. Damage to bearings may
result.
Tightening Pinion Shaft Nut
9. Hold pinion yoke with Yoke Holder 6719 and tighten shaft, nut to 597 Nm (440 ft. lbs.).
Rotate pinion shaft several revolutions to ensure the bearing rollers are seated.
