RAM 3500 Truck Front Door Window Regulator Removal Guide | Page 12059
Front Door Window Regulator: Service and Repair
Front Door Window Regulator - Installation
Power
INSTALLATION
1. Connect the door wire harness (6) to the window regulator (4) and install the regulator through the opening in the door (2).
2. Engage the two regulator bolts (7) to the door.
3. Install the bolt (5) that secure the window regulator to the door and tighten all three regulator bolts to 10 Nm (89 in. lbs.).
4. Position the regulator stabilizer (1) into the door and install the two nuts (3). Tighten the nuts to 10 Nm (89 in. lbs.).
5. Raise the window regulator (2) to the position shown.
6. Support the window glass and remove the wooden wedge or equivalent.
7. Position the window glass to the window regulator and install the two nuts (1) thought the two sight windows (3 and 4). Tighten the nuts to 10 Nm
(89 in. lbs.).
8. Disconnect the electric window switch from the door wire harness and reinstall the switch onto the door trim panel See: Sensors and
Switches/Sensors and Switches - Windows and Glass/Power Window Switch/Service and Repair/Installation .
9. Install the waterdam See: Front Door Panel/Service and Repair/Front Door Waterdam/Installation .
10. Install the inner belt molding See: Front Door Window Glass/Front Door Window Glass Weatherstrip/Service and Repair/Front Door Inner Belt
Molding/Installation .
Manual
INSTALLATION
