RAM 3500 Truck 2WD L6-5.9L DSL Turbo (2008)
6. Install the caliper (2) and the caliper slide pin bolts (4) See: Disc Brake Caliper - Installation .
7. Install the tire and wheel assembly. See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement .
Front - HD (Heavy Duty) Link/Coil Suspension
FRONT - HD (HEAVY DUTY) LINK/COIL SUSPENSION
NOTE: Petroleum based grease should not be used on any of the rubber components of the caliper, Use only a Non-Petroleum based grease,
such as Dow Corning-807(R) grease.
NOTE: Clean slide pin bores thoroughly to remove any old grease.
NOTE: Use grease packets included with kit or Dow Corning-807(R) grease.
1. Thoroughly coat the new slide pins (3) on all working surfaces.
2. Install the boot (2) onto the slide pin (3) and then insert into the adapter (1).
3. Push the pin (3) all the way into the adapter (1) and carefully expel the trapped air by gently pushing on the boot (2) near the slide pin head (3).
4. Install the caliper adapter mounting bolts (5). Tighten the mounting bolts to 339 Nm (250 ft.lbs).
