RAM 3500 Truck Harmonic Balancer - Crankshaft Pulley | Service Procedures
Harmonic Balancer - Crankshaft Pulley: Removal and Replacement
Vibration Damper - Removal
REMOVAL
1. Remove the accessory drive belt.
2. Remove the four (4) damper to crankshaft bolts and remove damper and speed indicator ring.
Vibration Damper - Installation
INSTALLATION
1. Install speed indicator ring.
NOTE: The speed indicator ring is located over a dowel pin.
2. Install the crankshaft damper and bolts. Tighten bolts to 40 Nm (30 ft. lbs.) torque, plus an additional 60°.
NOTE: The damper must be installed so the hole is located over the dowel pin.
3. Install the accessory drive belt.