RAM 3500 Truck 2WD L6-5.9L DSL Turbo (2008)
Battery Tray: Service and Repair
Battery Tray - Installation
INSTALLATION
LEFT SIDE
1. Position the battery tray assembly (1) and install the retaining bolts (2).
2. Connect the left front fender ground wire.
3. Install the battery temperature sensor in the battery tray See: Battery Temperature Sensor/Service and Repair/Battery Temperature Sensor -
Installation .
4. Install the cruise servo (3) (if equipped) and retaining screws.
5. Install the left front wheelhouse splash shield See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Installation .
6. Install the anti-lock brake controller (if equipped).
7. Install the purge solenoid (6) on its mounting bracket.
8. Connect the wire harness retainers on the battery tray assembly.
9. Install the Totally Integrated Power Module (TIPM) (5) See: Power and Ground Distribution/Power Distribution Module/Service and
Repair/Installation .
10. Install the battery (3) See: Service and Repair/Removal and Replacement/Battery - Installation .
RIGHT SIDE
