RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1999)
Valve Cover: Service and Repair
REMOVAL
1. Disconnect both battery negative cables.
Cylinder Head Cover And Gasket
2. Loosen the five (5) cylinder head cover bolts. Remove the front three bolts and leave the rear two bolts in the cover.
3. Lift cover off of cylinder head.
CLEANING
Using a suitable solvent, Clean and dry gasket mating surfaces on cylinder head and cover. Wipe gasket dry and inspect for re-use.
INSPECTION
The cylinder head cover gasket and isolators are reusable. However, should cracks be present in the rubber/silicone construction, the defective
components should be replaced.
INSTALLATION
1. Install the gasket as shown. Make sure the gasket is properly located around the cylinder head bolts, with the words "top front" facing up and
towards front of engine.
2. Place two bolts and isolators into the rear two mounting holes and install the cover.
3. Install the remaining bolts and isolators. Starting with the center bolt, torque in a circular pattern to 24 Nm (18 ft. lbs.).
4. Connect both battery negative cables.