RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1999)
Fig. 7
7. Seat yoke on pinion shaft with Installer D-191 and Wrench 6719.
8. Remove the tools and install the pinion yoke washer and nut.
CAUTION: Do not exceed the minimum tightening torque when installing the pinion yoke retaining nut at this point. Damage to bearings may
result.
Fig. 8
9. Hold pinion yoke with Yoke Holder 6719 and tighten shaft nut to 597 Nm (440 ft. lbs.). Rotate pinion shaft several revolutions to ensure the
bearing rollers are seated.