RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2002)
16.
Install the sleeve, 0-ring end first, into the bore by hand. Using a press or rubber mallet, fully press the sleeve into the bore until seated (Fig. 9).
Verify the cross coupling plate rotates freely. Verify the 0-ring has not been pinched or is out of position.
17.
Install the larger 0-ring included in the service kit in the clean groove of the vacuum pump housing (Fig. 10). Lightly lubricate 0-ring with engine
oil.
18.
Carefully install the bearing housing to the vacuum pump housing, making sure dowel pin seats into the dowel hole, and the shaft drive tangs align
with the cross coupling slot (rotate the pump shaft if necessary (Fig. 10). Secure with two M10 cap screws and torque to 30 Nm (22 ft-lb).
CAUTION:
Failure to align drive tangs with the cross coupling slot prior to tightening cap screws will result in pump damage.
19.
Inspect the Power Steering pump drive lug and clean any old seal residue from its surface using solvent and a rag.
