RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2002)
Headlamp Bulb: Service and Repair
REMOVAL
On the driver side, the battery and battery tray must be removed to service the headlamp bulb.
1. Disconnect and isolate the battery negative cable.
2. Remove the battery tray.
3. Disengage wire connector from headlamp bulb(s).
Fig. 13 Headlamp Bulb
4. Remove retaining ring holding bulb(s) to headlamp.
5. Pull bulb(s) from headlamp.
INSTALLATION
CAUTION: Do not touch the bulb glass with fingers or other oily surfaces. Reduced bulb life will result.
1. Position bulb(s) in headlamp.
2. Install retaining ring holding bulb(s) to headlamp.
3. Connect wire connector to headlamp bulb(s).
4. Install battery tray, if removed (Refer to ELECTRICAL/BATTERY SYSTEM/TRAY - INSTALLATION).
5. Connect battery negative cable.