RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2002)
2. Remove cable cover (Fig. 6). Cable cover is attached with 2 Phillips screws, 2 plastic retention clips and 2 push tabs (Fig. 6). Remove 2 Phillips
screws and carefully pry out 2 retention clips. After clip removal, push rearward on front tab, and upward on lower tab for cover removal.
Fig.7 Cables At Throttle Lever
3. Using finger pressure only, disconnect end of speed control servo cable from throttle lever pin by pulling forward on connector while holding lever
rearward (Fig. 7).DO NOT try to pull connector off perpendicular to lever pin. Connector will be broken.
4. Using two small screwdrivers, pry throttle cable connector socket from throttle lever ball (Fig. 7). Be very careful not to bend throttle lever arm.
5. Disconnect transmission control cable at lever arm (if equipped).
6. Squeeze pinch tabs on speed control cable (Fig. 7) and pull cable rearward to remove from cable mounting bracket.
7. Squeeze pinch tabs on throttle cable (Fig. 7) and pull cable rearward to remove from cable mounting bracket.
8. If equipped with an automatic transmission
9. Disconnect wiring harness clip (Fig. 8) at bottom of bracket.