RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2002)
3. Install the vacuum pump bracket to steering pump nuts and tighten to 24 Nm (18 ft. lbs.).
4. Position new gasket on vacuum pump assembly. Use sealer if necessary to retain the gasket.
5. Align and install the pump assembly on the engine. Ensure the steering pump stud is inserted into the block bracket. Tighten the pump- to-engine
block attaching bolts to 77 Nm (57 ft. lbs.).
6. Install the steering pump to attaching bracket nut and tighten to 24 Nm (18 ft. lbs.).
7. Remove plug and install the oil pressure sending unit and electrical connector.
8. Install the oil feed line to the vacuum pump. Tighten the oil line connection to 7 Nm (60 inch lbs./ 5 ft. lbs.).
9. Install the fluid hoses to the power steering pump. Tighten the pressure fitting at the pump to 31 Nm (23 ft. lbs.).
10. Install and clamp the hose on the vacuum pump.
11. Install the serpentine belt.
12. Fill the reservoir with power steering fluid.
13. Start the engine and check the operation of the brakes.
