RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2002)
Fluid Pump: Testing and Inspection
47RE - AUTOMATIC TRANSMISSION
OIL PUMP VOLUME CHECK
Measuring the oil pump output volume will determine if sufficient oil flow to the transmission oil cooler exists, and whether or not an internal
transmission failure is present.Verify that the transmission fluid is at the proper level. If necessary, fill the transmission to the proper level with Mopar
ATF +4, type 9602, Automatic Transmission Fluid.
1. Disconnect the To cooler line at the cooler inlet and place a collecting container under the disconnected line.
CAUTION: With the fluid set at the proper level, fluid collection should not exceed 1 quart or internal damage to the transmission may occur.
2. Run the engine at curb idle speed, with the shift selector in neutral.
3. If one quart of transmission fluid is collected in the container in 20 seconds or less, oil pump flow volume is within acceptable limits. If fluid flow
is intermittent, or it takes more than 20 seconds to collect one quart of fluid, refer to the Hydraulic Pressure tests for further diagnosis.
4. Re-connect the To cooler line to the transmission cooler inlet.
5. Refill the transmission to proper level.
