RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2002)
Seals and Gaskets: Service and Repair
NV4500 - Manual Transmission
Adapter Housing Seal
ADAPTER HOUSING SEAL NV4500
REMOVAL
1. Raise and support vehicle.
2. Mark the propeller shafts and yokes for installation reference and remove the shafts.
3. Support transmission with a transmission jack.
4. Remove engine rear support.
5. Remove transfer case.
6. Remove adapter housing seal with a pry tool or slide hammer mounted screw (Fig. 128).
INSTALLATION
1. Install adapter housing seal with Installer C-3860-A and Handle C-4171.
2. Install transfer case.
3. Install propeller shafts with reference marks aligned.
4. Fill transfer case and transmission to proper level.
5. Remove support and lower vehicle.
Extension Housing Seal
EXTENSION HOUSING SEAL NV4500
REMOVAL
1. Raise and support the vehicle.
2. Mark the propeller shaft and yoke for installation reference.
3. Remove the propeller shaft.