RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
Oil Pressure Sender: Service and Repair
OIL PRESSURE SENSOR/SWITCH
REMOVAL
1. Disconnect the battery negative cables.
2. Disconnect the oil pressure switch connector.
3. Using a suitable socket, remove the oil pressure switch from the block (counter-clockwise).
INSTALLATION
1. If the switch is not being replaced, replace and lubricate the O-ring.
2. Install the oil pressure switch and tighten to 18 Nm (159 in. lbs.) torque.
3. Connect oil pressure switch connector.
4. Connect the battery negative cables.
5. Start engine and check for oil leaks at the switch.
