RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
NOTE:
Whenever a controller is programmed, the software in the DRBIII must be programmed with the latest revision level available.
1.
Using a CH7025 cable, connect the DRBIII to the external power supply.
2.
Before beginning the reprogramming procedure, remove any old flash reprogramming files from the DRBIII memory. To clear the memory:
a.
Start at the "MAIN MENU" screen and simultaneously press the "More" and "Yes" keys.
b.
A screen will appear requesting a "Cold Boot".
c.
Follow the on screen instructions by selecting the "F4" key.
d.
When the DRBIII reboots to the MAIN MENU, proceed to Step #3.
3.
Using a CH7035B cable, connect the DRBIII to TechCONNECT.
4.
Open "TechTOOLS" and verify that the "DRBIII Status: Connected" message is in the upper right corner of the TechTOOLS screen.
5.
In the criteria box on the TechCONNECT screen, enter the last 9 digits of the Vehicle Identification Number (VIN), or use the Y.M.E. session
function.
6.
Click on the "Show Updates" button at the bottom of the TechCONNECT screen.
7.
For 2003 models there will be three flash files available for this recall. Download all three flash files by depressing the control key on the
TechCONNECT keyboard and then selecting the three flashes listed below.
56049681AC / 56051036AF flashes are for the FCM.
MIC02DRV38 flash is for the CCN.
NOTE:
Only two of the three flash files downloaded to the DRBIII will be used. The DRBIII will automatically select the correct flash for the FCM based on
the FCM part number in the vehicle.
8.
For 2004 2005 models there will be two flashes available for this recall. Depress the control key on the TechCONNECT keyboard and then select
the two flashes listed below.
56051036AF flash is for the FCM.
MICDRV0052 flash is for the CCN.
9.
Click on the "Download/Update" button on the bottom of the TechCONNECT screen.
10.
Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT. When the flash
process is complete, proceed to Step 11.
11.
Disconnect the DRBIII from TechCONNECT and the external power supply.
