RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
PARTS REQUIRED:
REPAIR PROCEDURE:
1.
Disconnect the negative battery cable.
2.
Remove the PCM.
3.
Install the appropriate PCM from the Parts Required section above.
4.
Remove the transmission wire harness from the vehicle and Install the appropriate new harness listed above.
5.
Make sure to fully seat the harness connector into the PCM. Push the harness connectors slowly into the PCM. Two clicks will be heard when the
connector is seated. This assures that both latches are secure.
6.
Connect the negative battery cable.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
