RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
Fig.4 Apps Connector
10. Remove 6 mounting bolts and partially remove APPS assembly from engine. After assembly is partially removed, disconnect electrical connector
from bottom of sensor by pushing on connector tab.
11. Remove APPS assembly from engine.
Late Diesel Engines
Fig.5 Apps Location (Late)
The APPS is serviced (replaced) as one assembly including the sensor, plastic housing and cable. The APPS assembly is located under the left vehicle
battery tray. Access to APPS is gained from over top of left / front tire.
1. Disconnect negative battery cable at battery.
2. Disconnect APPS cable at accelerator pedal. Refer to Accelerator Pedal Removal/Installation.
3. Remove wheel house liner at left I front wheel. Refer to Body