RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
c.
"All (Except Below)"
d.
"Engine"
e.
"Module Display"
f.
Record the "ECM part number" on the repair order for later reference.
NOTE:
If the ECM is not operational, the "ECM part number" can be obtained from the label on the controller. For 2003 and later vehicles, if the label on
the controller is not legible, record the "Reference No." for use later. The "Reference No." is located in the Reference No. box at the top, center of
the Engine Data Plate (Fig. 1). Do not use the reference number shown in the figure. The Engine Data Plate is located on the intake side of the
breather cover or affixed to the APPS bracket.
3.
Page back to the "Main Menu"
4.
Determine if the vehicle is equipped with SKIM. Using the DRBIII® select:
a.
"DRBIII Standalone"
b.
"1998 - 2007 Diagnostics"
c.
"All"
d.
"System Monitor"
e.
"J1850 Module Scan"
f.
Look for "SKIM" in the list of modules.
5.
If the vehicle is not equipped with SKIM then proceed to Step # 6. If the vehicle is equipped with SKIM obtain the vehicle Personal Identification
Number (PIN) before continuing with Step # 6. This information is available from:
a.
The original selling invoice.
