RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
NOTE:
If the ECM is not operational, the "ECM part number" can be obtained from the label on the controller. For 1998-1/2 - 2002 vehicles, if the label on
the controller is not legible, proceed to next step. For 2003 and later vehicles, if the label on the controller is not legible, record the "Reference No."
for use later. The "Reference No." is located in the Reference No. box at the top, center of the Engine Data Plate (Fig. 1).
Do not use the reference number shown in the figure. The Engine Data Plate is located on the intake side of the breather cover or affixed to the APPS
bracket.
2.
Page back to the "Main Menu"
3.
Determine if the vehicle is equipped with SKIM. Using the DRBIII(R)select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All"
d.
"System Monitor"
e.
"1850 Module Scan"
f.
Look for "SKIM" in the list of modules.
4.
If the vehicle is not equipped with SKIM then proceed to (STEP # 5). If the vehicle is equipped with SKIM obtain the vehicle Personal
Identification Number (PIN) before continuing with (STEP # 5). This information is available from:
a.
The original selling invoice.
b.
The DealerCONNECT system under the "Sales" or "Parts" tabs - select "Key Codes".
c.
By contacting the District Manager.
CAUTION:
Failure to install the SKIM pin number into the module after flashing the Cummins ECM will cause a start and stall condition.
5.
Open the hood, install a battery charger and verify battery state is above 11.5 volts.
