RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
SPECIAL TOOLS / EQUIPMENT REQUIRED:
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
Repair Procedure
NOTE:
Whenever a controller is programmed, the software in the DRBIII(R) must be programmed with the latest revision level available. Current software
version is 63.3.
NOTE:
If this flash process is interrupted/aborted, the flash process should be restarted and then follow the directions on the DRBIII(R).
NOTE:
Remove any unnecessary PCMCIA cards prior to starting a DRB III(R) flash.
1.
Before beginning the reprogramming procedure, remove any old flash reprogramming files from the DRBIII(R) memory. To clear the memory
from the MAIN MENU power up the DRBIII(R) and then:
a.
Simultaneously press the "MORE" and "YES" keys.
b.
A screen will appear requesting a "COLD BOOT".
c.
Follow the on screen instructions by selecting the "F4" key.
d.
When the DRBIII(R) reboots to the MAIN MENU, proceed to Step # 2
2.
With the ignition switch in the "RUN" position, determine and record the "ECM part number" of the ECM currently in the vehicle. Using the
DRBIII(R) select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2007 Diagnostics"
