RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
b.
The DealerCONNECT system under the "Parts" tabs - select "Key Codes".
c.
By contacting the District Manager.
CAUTION:
Failure to install the SKIM pin number into the module after flashing the Cummins ECM will cause a start and stall condition.
6.
Install a battery charger and verify that the charging rate provides approximately 13.2 - 13.8 volts. Set the battery charger to continuous charge. Do
not allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is complete.
NOTE:
When reprogramming a Cummins ECM be sure to do the following;
^
Download the flash file from TechCONNECT to the DRBIII(R) with the DRBIII(R) disconnected from the vehicle.
^
Download the flash file from the DRBIII(R) to the vehicle with the DRBIII(R) disconnected from TechCONNECT.
7.
Connect the DRBIII(R) to TechCONNECT. Open TechTOOLS and verify that the "DRBIII(R) Status: Connected" message is in the upper right
corner of the TechTOOLS screen.
8.
Enter the old Cummins "ECM part number" obtained from the DRBIII(R) in Step # 2 into the "Parts Criteria" window.
9.
Select "Show Updates".
10.
Highlight the proper flash file from the list:
a.
If the old "ECM part number" is known, highlight the flash file listed, based on the old "ECM part number" recorded earlier Step # 2.
b.
If the old part number is not known, highlight the proper flash file based on the Reference No. located in the "Ref. No." box, at the top,
center of the Engine Data Plate (Fig. 1).
11.
Select the "DRBIII" radio button which is next to the "Download/Update" button.
12.
Select the "Download/Update" button.
13.
Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT. When the flash
process is complete, proceed to the next step.
14.
Disconnect the DRBIII(R) from TechCONNECT.
15.
Connect the DRBIII(R) to the vehicle.
16.
Download the flash file from the DRBIII(R) to the vehicle. Using the DRBIII(R) select:
a.
"Vehicle Flash"
b.
Follow the directions on the DRBIII(R) screen. When the flash process is complete, proceed to the next step.
17.
If the vehicle is equipped with SKIM, proceed to Step # 18. If the vehicle is not equipped with SKIM, proceed to Step # 19.
18.
On vehicles equipped with SKIM, transfer the VIN and Security Key information from the SKIM to the ECM. Using the DRBIII(R) select:
a.
"DRBIII Standalone"
b.
"1998 - 2007 Diagnostics"
c.
"All"
d.
"Theft Alarm"
e.
"SKIM"
f.
"Miscellaneous"
g.
"Cummins ECM Replaced"
