RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
Stabilizer Bushing: Service and Repair
Front
REMOVAL - CONTROL ARM BUSHING
1. Install bushing remover tools 8682-2 (adapter), 8682-3 (receiver) and 8682-4 (driver) with the threaded rod and the two bearings as shown
REMOVAL - TORSION BAR CROSSMEMBER BUSHING
1. Remove the torsion bar crossmember.
2. Secure the crossmember in a vise.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
3. Install special tools 8838 threaded rod, 8835-1, 8835-4 and 8835-3 as shown in the graphic.
4. Press out the bushing.
REMOVAL - LOWER CONTROL ARM BUSHINGS - 2WD (LD)