RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN C (2003)
Fig.17 Washer Reservoir Remove/Install - V-10 & Diesel Engine
7. Remove the two screws that secure the washer reservoir to the left vertical member of the radiator support.
8. Remove the washer reservoir from the left side of the engine compartment.
INSTALLATION
1. Position the washer reservoir into the left side of the engine compartment.
2. Install and tighten the two screws that secure the washer reservoir to the left vertical member of the radiator support. Tighten the screws to 10 Nm
(85 in. lbs.).
3. Reconnect the left headlamp and dash wire harness connector for the washer pump/motor unit to the motor connector receptacle.
4. Reconnect the left headlamp and dash wire harness connector for the washer fluid level switch to the switch connector receptacle.
5. Reconnect the reservoir washer hose to the barbed nipple of the inline fitting at the engine compartment washer hose in the right headlamp and
dash wire harness.
6. Engage the reservoir washer hose into the integral routing clips on the top of the radiator fan shroud.
7. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
8. Reconnect the battery negative cable.
9. Close and latch the hood.
