RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Hood Sensor/Switch (For Alarm): Service and Repair
Vehicle Theft Security Hood Ajar Switch - Installation
Bracket
BRACKET
1. Position the hood ajar switch mounting bracket (3) onto the upper radiator cross member (1)
2. Install and tighten the fastener (2) that secure the mounting bracket to the upper radiator cross member, tighten the bolt to 5.5 Nm (4 ft lbs.).
3. Reinstall the hood ajar switch (2) into the mounting bracket. See: Switch.
Striker
STRIKER
1. Position the hood ajar switch striker (3) over the mounting hole in the inner hood panel (1) over the hood ajar switch.
2. Using hand pressure, press the hood ajar switch striker (3) upward into the mounting hole in the inner hood panel (1) until all three integral lock
tabs (2) are fully engaged.
3. Close and latch the hood.
Switch
SWITCH