RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
3. Lower the overhead console from the headliner far enough to access the wire harness connectors.
4. Disconnect the reading lamp wire harness connector (1).
5. Disconnect the sunroof switch wire harness connector, if equipped.
6. Disconnect the inferred temperature sensor wire harness connector (4), if equipped.
7. Disconnect the power sliding glass wire harness connector (2), if equipped.
8. Disconnect the Homelink(R) transceiver wire harness connector (3), if equipped.
9. Remove the overhead console from the vehicle.
Overhead Console - Installation
INSTALLATION
1. Position the overhead console near the mounting location on the headliner and connect the wire harness connectors.
2. Connect the reading lamp wire harness connector (1).
3. If equipped, connect the sunroof switch wire harness connector.
4. If equipped, connect the inferred temperature sensor wire harness connector (4).
5. If equipped, connect the power sliding glass wire harness connector (2).
6. If equipped, connect the Homelink(R) transceiver wire harness connector (3).
7. Align the snap clips on the overhead console housing with their receptacles (5) in the overhead console bracket.
8. Push upward firmly and evenly on the sides of the overhead console housing over the snap clip locations until the snap clips are fully engaged
with the receptacles in the overhead console bracket.
9. Reconnect the battery negative cable.
Floor Console - Removal
REMOVAL
