RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Sunroof / Moonroof Motor: Service and Repair
Sunroof Motor - Removal
REMOVAL
WARNING: Do not attempt to move or reposition the sunroof glass panel or drive cables with the motor/module removed. Vehicle/sunroof
damage or personal injury may result.
WARNING: The sunroof must first be calibrated and the Motor/Module Initialization Procedure must be completed any time a sunroof
motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or
personal injury. See: Testing and Inspection/Programming and Relearning/Sunroof Position Calibration for the appropriate
procedure.
1. Disconnect the battery negative cable.
2. Remove the vehicle headliner, See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Removal.
3. Remove the power sunroof motor/module electrical connector (2).
4. Remove the retaining screws (3) and remove the motor/module (1) from the vehicle.
