RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Power Seat Motor: Service and Repair
Power Seat Motor - Installation
Lumbar Motor
INSTALLATION
1. Install parts from old seat back assembly as necessary. (1)
2. Install the seat back See: Seat Back/Service and Repair/Removal and Replacement/Seat Back - Installation.
Adjuster Motor
INSTALLATION
FRONT TILT MOTOR
1. Position the front tilt motor (1) to the seat adjuster and install the screws. Tighten the screws to 5 Nm (44 in. lbs.).
2. Connect the electrical connector.
3. Install the seat cushion cover, cushion and pan.
4. Clip the wire harness to the pan.
5. Install the seat assembly See: Service and Repair.
6. Reconnect the negative battery cable.
REAR TILT MOTOR