RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
1. Install caliper (6) to the caliper adapter (1).
2. Coat the caliper mounting slide pin bolts (3) with silicone grease. Then install and tighten the bolts to 30 Nm (22 ft. lbs.).
CAUTION: Verify that the brake hose is not twisted or kinked before tightening the fitting bolt.
3. Install the brake hose (4) to the caliper (6) with new seal washers and tighten fitting bolt to 27 Nm (245 in. lbs.).
4. Remove the prop rod from the brake pedal.
5. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed.See: Brake Bleeding/Service and Repair.
6. Install the wheel and tire assemblies See: Maintenance/Wheels and Tires/Specifications.
7. Remove the supports and lower the vehicle.
8. Verify a firm pedal before moving the vehicle.
Front
FRONT
1. Raise and support the vehicle, See: Maintenance.
2. Remove the front wheel and tire assembly.
3. Remove the caliper slide pin bolts (4)See: Disc Brake Caliper - Removal.