RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to
hang the caliper securely.
7. Remove the inboard and outboard brake pads (1).
8. Remove the anti-rattle clips (2).
9. Remove the caliper adapter mounting bolts (4).
10. Remove the caliper adapter.
Front
FRONT
NOTE: Petroleum based grease should not be used on any of the rubber components of the caliper, Use only a Non-Petroleum based grease,
such as Dow Corning-807(R) grease.
NOTE: Clean slide pin bores thoroughly to remove any old grease.
NOTE: Use grease packets included with kit or Dow Corning-807(R) grease.
1. Thoroughly coat the new slide pins (3) on all working surfaces.
2. Install the boot (2) onto the slide pin (3) and then insert into the adapter (1).
3. Push the pin (3) all the way into the adapter (1) and carefully expel the trapped air by gently pushing on the boot (2) near the slide pin head (3).
