RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Water Pump: Removal and Replacement
Water Pump - Removal
6.7L DIESEL ENGINE
1. Disconnect battery negative cables.
2. Drain cooling system See: Service and Repair.
3. Disconnect ambient air temp sensor electrical connector and mass airflow sensor electrical connector (if equipped).
4. Remove turbocharger inlet tube and air filter housing. For 5.9L Diesel, See: Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Air Cleaner Body - Removal , for 6.7L Diesel, See: Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Air Cleaner Body - Removal.
5. Remove generator assembly See: Starting and Charging/Charging System/Alternator/Service and Repair/Generator - Removal.
6. Remove the accessory drive belt See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Serpentine Accessory
Drive Belt - Removal.
7. Remove water pump mounting bolts (1).
8. Remove O-ring from water pump (2).
9. Remove water pump (2). Clean water pump sealing surface on cylinder block.
Water Pump - Installation
6.7L DIESEL ENGINE
